XMeye - How to Set Up Motion Detection Push Function on the App Sannce Vision? – Sannce

Applies to: DN41CS/DN81BS/DT61BH/DT81BF/DT31BZ

The article will introduce how to set up the motion recording Push Function on the App Sannce Vision.

1. Install the HDD.

Please confirm that if you have installed the HDD inside the box. Here is the instruction on how to install the hard drive disk.
https://support.sannce.com/hc/en-us/articles/900000433303

If the Status of HDD is Error or the hard drive can't be recognized, please follow this link to fix it:

2.Make sure the DVR connects to the internet.

When your local monitor shows Connected, it means the DVR is connected to the network:

If it shows Not connected, it means the DVR is not connected to the network:

Note: If the status is not connected, it means the recorder did not connect to the cloud successfully.

Here is the relevant link to offer help.

3.Set up the motion detection on the main screen.

Please follow the link below to set up the motion detect recording on your system first:

Note:

Please make sure enable Mobile reported option.

(This step is very important.)

4.Enable the motion detection Push function on the Sannce Vision App.

Note: If you do not know how to device to the Sannce Vision App, here is the relevant link to offer help.

a.After adding the device to on the App from your phone successfully, please click the Alarm Button.

b.Then choose the Alarm Push. Open the Alarm Push button.

5.Test successfully.

Then you can receive the notification on your operating page from your phone.

If you still have some issues during setting up this function, please feel free to contact SANNCE technical support at support@sannce.com by email.

XMeye - How to Set Up Motion Detection Push Function on the App Sannce Vision?