XMeye - What to Do if System Stays on the Startup Picture?

Applies to:

DL41B/DL81B/DL41A/DL81A/DL41D/DL81D/DH81S/DH81X/DH81NG/DM41D/DM41A/DM81A/DN41D/DN81D/DN41S/DN41NA/DM41H/DM81H/DM21O/DM31O/DE41N/DE81N/DN81NB/DM81Z/DM61W/DG81CP/DG81CQ/DH81NK/DG81CR/DH41NK/DM41G/DN41CJ/DN81BJ/DN61EC/DG81W/DG61X/DG41T/DT81DQ/DT41DC/DT61ER/DG41BE/DG81BE/DN81Q/DN41Q/NP41F/N43SU/N44SU/N48PZ/N481U/N441U/N44PBD/N461W/N48PAU/NW41V/N441H/N441K/N28WEB/N441B/N441D/N441L/N44PAN/N44PAJ/N34WDB/N34WDD/N44WEB/N44WED/N44WEC/NW41V

As usual, when you connect recorder to power supply, monitor will show Sannce logo about 10 seconds. Then you will hear a beep and see video of camera (if cameras are connected) and you can see setting interface on the screen.

If it enters the procedure to Sannce logo or its stays color mode,it's means the system doesn't power on successfully.

Please refer to these ways below to have a trty.

1. If you are using HDMI port on recorder, pls try VGA port if you can.

2. Unplug power supply and plug it again for several times.

3. Try another adapter.

4. Unplug all cameras.

5. Uninstall hard disk drive if it is pre-installed.