Type 1-N98PBD-How to Set Up Motion Detection Recording?

Applies to: N98PBD

The NVR needs an internal hard disk drive for recording. Without the hard drive, the system can show live viewing, but can’t record, playback either.

Please connect the NVR to the monitor and setup it on your monitor.

1. Go to the Advanced-->HDD info on your monitor to check if hard is working.

Motion detection recording means DVR will record automatically when it is triggered by movement.
1. Go to Main Menu-->Record Conf-->Storage, select Channel, tick Schedule, and Detect.

This step is necessary and you can‘t skip it. Please don‘t tick Manual or stop, or regular.

2.  Motion Detect setting

1) Go to Alarm-->Intelligent Alert

2) Tick “Enable”

select “human detection”, “Advanced-Set” and “Sensitivity” according to your needs and click “OK” to save.

3) Click ‘Rule-Set to’ set region. You could click step 1. and 2, depending on your needs. You can change the region by clicking the shape(See step 3), dragging the mouse, and drawing the area. Finally, click ‘OK’ to save and quit， and after you set it up, it will record if the system detects the motion signal.

3. Go to Play Back to check if it takes motion detection recording. If you find you can‘t select channels 3 and 4, here is a solution. 

https://support.sannce.com/hc/en-us/articles/900001994006